Carson Reflex Wheel Pro Manuel d'instructions télécharger pdf (Page 63)

CARSON Reflex Wheel Ultimate Touch 500500516

Telemetry module FS-SVT01

Battery voltage recognition module

Procedure:

1. Connect one end of the 3-pin connecting cable

to the “Out” terminal of the telemetry module

and the other end to the “IN” terminal of the

receiver, or to the “IN” terminal of one of the

sensors already connected.

Switch on the transmitter and the model (receiver).

“Ext.voltage4: 12.40V” will now be displayed on

the main screen, which means that the installation

was successful.

Next, connect the red and black contact connector

to the balancer terminal of your LiPo driving

battery. The red connector is for the positive

terminal and the black for the negative terminal

(outermost black cable on the balancer connector,

see diagram).

Warning!!!

The polarity of the red and black connectors must

never be reversed. Doing so would damage the

electronic components.

Example: “Ext.voltage4: 12.4V” is displayed on the

transmitter screen. This is the current voltage value

of your LiPo battery which is connected to the

sensor module.

Advice

The sensor modules must always be connected to

the “IN” terminal. Do not connect the sensors to the

“OUT” terminal, as otherwise incorrect values are

transmitted to the receiver and the receiver and the

telemetry modules can be damaged.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 95 96

Pas de commentaire

Carson Reflex Wheel Pro Manuel d'instructions Page 63